Silvercrest SKWD B1 - Manual (Page 9)

9 GB/IE
Safety Instructions for Batteries / Start-up / Changing the battery / Operation
Remove the battery if the product
is not going to be used for an
extended period.
When inserting the battery ensure
that it is inserted the right way
round! This is shown in the bat-
tery compartment. Otherwise the
battery can explode.
Insert the battery with care. Oth-
erwise the product can be dam-
aged.
Please do not dispose of used
batteries in your household waste,
but take them to a designated
collection depot for special waste.
Start-up (Fig. A)
Pull the insulating strip out of the battery com-
partment in the direction of the arrow.
Or:
Open the battery compartment at the back of
the product by pressing the tab of the battery
cover toward the battery compartment and
lifting it upward.
Remove the insulating strip. It is located between
the battery
5 and the battery compartment.
Replace the battery cover. Be sure the two
extensions on the battery cover engage in the
opening for the battery cover. Press the battery
cover onto the battery compartment until you
hear and feel it lock into place.
Changing the battery
Open the battery compartment at the back of
the kitchen scales
1 as described above.
Remove the drained battery.
Insert the new battery (1 x CR2032). Check the
polarity of the battery during insertion. The „+“
sign must point upward and the battery remain
inside the battery compartment.
Close the battery compartment as described
above.
Operation
Setting the unit (Fig. B)
Place the kitchen scales 1 on a solid, level,
and flat surface.
Press the ON / OFF button / TARE button 3 to
switch on the kitchen scales 1 .
Select the weight unit by pressing the UNIT
button
4 . You may select between „g“, „oz“,
„lb:oz“, „ml“, „fl.oz“.
Weighing (Fig. C)
Place the kitchen scales 1 on a solid, level,
and flat surface.
Press the ON / OFF button / TARE button 3 to
switch on the kitchen scales 1 . The LC display
will read „0“.
Place the item you wish to weigh onto the
scales. The LC display
2 will show the weight
of the items.
Tare (Fig. C)
First follow the three steps in section „Weighing“.
Briefly press the ON / OFF button / TARE
button 3 . The LC display 2 will read „ 0“
and „TARE“ will appear.
Add other items you wish to weigh to the
scales. The LC display 2 will show the weight
of the item added.
When removing the added items from the
scales, the LC display 2 will read „ 0“.
When removing all items being weighed, the
scales will display a negative value.