Echo 99944200545 - Manual (Page 8)

8
c
ontents
The ECHO product you purchased has been factory pre-assembled for your convenience. Due to packaging restrictions,
shield installation and other assembly may be necessary.
After opening the carton, check for damage. Immediately notify your retailer or ECHO Dealer of damaged or missing
parts. Use the contents list to check for missing parts.
_____ 1 - PAS Hi Torque Trimmer Attachment
_____ 1 - Operator's Manual
_____ 1 - Safety Manual
_____ 1 - Warranty Registration Card
_____ 1 - Locking Tool
_____ 1 - T-Wrench
_____ 1 - Plastic Debris Shield
_____ 1 - Nylon Trimmer Head
_____ 1 - Safety Goggle
_____ 1 - Shield Plate
_____ 3 - 5mm x 16mm Screws (shield mounting)
_____ 1 - Storage Hook Assembly
Tools Required: None
Parts Required: PAS or SRM-SB Power Head w/Shaft & Coupling.
1. Set Power Head/Shaft Assembly on a level surface.
2. Pull locator pin (A) out, and turn counter-clockwise 1/4 turn to lock-
out position.
3. Remove vinyl cap from attachment drive shaft.
4. Carefully fit attachment drive shaft assembly into coupler (B) to
decal assembly line (C), making sure that the inner lower drive shaft
engages into the square upper drive shaft socket.
NOTE
Earlier model Power Heads may have shorter couplings. Short
couplings fit flush to decal point (E). New couplings are 4-3/4 in.
long, and fit flush to line (C).
NOTE
Lower bearing housing and head assembly must be in line with the
engine.
a
ssembly
power head shaft
/
lower shaft assembly
A
B
D
E
C