Silvercrest SNMD 33 A1 - Manual (Page 77)

The thread spool pins (C, D) serve to
hold the thread spools in place while
thread is being fed to the sewing machine.
To use the spool pin, pull it upwards. To
store it, push it down.
If you are using thread which tends to
wraps itself around the spool pin, put
the thread on the thread spool pin (C)
and guide the upper thread (A) through
the eye (B) in the thread spool pin (D),
see Fig. The eye (B) should point in
the direction of the thread spool.
Note:
C
D
E
a
E
p
B
A
1 2
3 4
GB / IE 77
Attaching the presser foot holder
Important:
1. Install the presser foot holder
2. Inserting the presser foot
3. Removing the presser foot
4. Inserting the edge/ quilt guide (p)
Turn the main switch (20) to off ("O")
when carrying out all the operations!
Raise the presser bar (A) by lifting the
two-step presser foot lifter (18) Attach
the presser foot holder (B) as
illustrated.
Lower the presser foot bar (B) until the
groove (C) is directly above the pin (D).
Lower the presser foot bar (A) as far
as it will go. The presser foot (a) will
engage automatically.
Raise the presser foot.
Press the lever (E) gently towards the
front and the presser foot disengages.
As shown in the illustration carefully
insert the edge/ quilt guide (p) e.g. For
hems, pleats, etc.
Getting ready
C D
A
B
C D
Setting up the thread spool pins