Silvercrest SSK 100 A1 - Manual (Page 10)

10 GB
Cleaning and Care / Storage / Disposal Start-up / Cleaning and Care
Switching on / off / Selecting
the temperature
Switching on:
Set the control unit 1 to 1, 2, 3, 4, 5 or 6, to
switch on the heating pad.
Note: The function display
2 illuminates after
the heating pad is switched on.
Note: This heating pad features rapid heating,
which allows it to heat up within the first 10
minutes of operation.
Switching off:
Set the control unit 1 to 0 to switch off the
heating pad.
Note: The operating display 2 will switch off.
Selecting the temperature:
Just before using the heating pad, set it to the
highest temperature setting (setting 6). This will
cause the heating pad to warm up quickly.
When using the heating pad for several hours, set
it to the lowest temperature setting (setting 1).
When operat-
ing the heating pad for several hours,
we commend setting the control unit
1
to the lowest setting to prevent over-
heating and potential burns to the
part of the body heat is applied to.
Temperature levels
Set the required temperature level on the con-
trol
1 (see fig. A).
Level 0: off
Level 1: minimum heat
Level 2–5: customised settings
Level 6:
maximum heat
Automatic switch-off
Note: The heating pad switches itself off automati-
cally after about 90 minutes. The function display
2
then starts to flash.
Then select the setting 0 and after about 5 sec-
onds, reset the heating pad to the desired tem-
perature setting to switch it on again.
If the heating pad is no longer used after
the timer expires:
– switch off the heating pad (Setting 0),
– unplug from the socket,
– disconnect the plug-in connection
3 , i.e. the
control unit 1 , from the heating pad.
Cleaning and Care
DANGER TO
LIFE BY ELECTRIC SHOCK! Always
remove the mains plug from the socket
and the plug-in connector 3 with the control 1
from the heating pad (see fig. B) before cleaning
the heating pad. Otherwise there is a risk of
electric shock.
Use a dry, lint-free cloth for control unit 1
cleaning and care.
RISK OF DAMAGE TO THE
PRODUCT OR PROPERTY! Never
immerse the control
1 in water or
other liquids. It may otherwise be damaged.
Always remove the inner cushion 4 before
cleaning the casing with built-in heating pad 6 .
Do so by opening the zip 5 (see Fig. B).
If slightly soiled, use a dampened cloth and a
little liquid mild detergent, if necessary.
RISK OF DAMAGE TO THE
PRODUCT OR PROPERTY! Do
not clean with chemical cleaners or
scouring agents. The casing with built-in heat-
ing pad
6 , the inner cushion 4 or the control
unit 1 could otherwise be damaged.
The casing with built-in heating pad
6 is machine washable. Remove
the inner cushion 4 before doing