Operation – Silvercrest SUR 46 A1 User Manual
Page 80
80 GB/MT
Operation
Then fill the stainless steel tank
7
with normal tap water.
The liquid must cover the object that is to be cleaned, but must not
exceed the mark indicating the maximum filling height.
If the stainless steel tank
7
overflows, wipe off the outside of the
device immediately until dry.
Important! Never use the ultrasonic cleaning device without
water as the device may be damaged!
1. Close the cover
5
and insert the mains plug
12
.
The figure
(180 seconds) appears in the display
2
as
standard – this is the standard time for a normal degree of soiling.
2. Select the desired time from five possible intervals:
(
). Use the timer button
4
to set
the desired time according to the degree of soiling.
3. Press the On-switch
1
and start the cleaning process.
The blue indicator light
6
on the lid
5
illuminates while the time
in the display
2
counts down to 0.
Note: During the cleaning process a quiet vibration noise can be
heard; this is caused by the cleaning process.
4. After the set time has elapsed the cleaning process is automatically
stopped, the blue indicator lamp
6
goes off and the display
2
shows
. The originally selected time interval in minutes / symbol
remains visible.
5. Press the Off-switch
3
to stop the cleaning process prematurely
if necessary. The time remaining from the selected time interval is
shown on the display
2
. Press the On-switch
1
again to resume
the cleaning process
1
. Or select a new time interval using the
timer button
4
and press the On-switch
1
again.
Important! You can repeat the cleaning process in order to
intensify the cleaning effect.