EdgeStar EAC211TS - Manual (Page 4)

Control Panel and Display
Note: the buttons on the remote control have the same functionality as those on the main control
panel
x ON/OFF- this button turns the unit power on or off
x TIMER- each time this button is pressed, the digit in the middle of the display
increments up by 1. The digit in the display corresponds to the amount of time (in
hours) that the unit will run before shutting itself off. If you do not select a timer
setting, the unit will run continuously
x WATER - this button turns on or off the cooling, humidifying, and air cleaning
function. When the “COOLER/HUMIDIFIER” light on the control panel is lit, the
unit pumps water from its reservoir over the fabric water curtain. As air is drawn past
this water, the endothermic effects of evaporation result in cooling. Additionally,
particulate matter and smoke from the air will be “washed” out of the air and into the
water reservoir.
x SWING- this button turns on or off the oscillation function. When the unit oscillates,
the base remains still and the upper part of the tower turns back and forth, directing
airflow around the room
x SPEED- this button adjusts the speed. There are three speed settings for airflow. Note
that when the unit is initially turned on, it starts on medium speed and changes to low
speed automatically
x MODE- this button toggles the airflow functions. There are three functions:
o Normal/manual- this mode, represented by three horizontal wavy lines, allows
you to manually set the airflow speed
o Natural/variable- this mode, represented by a mountain, automatically shifts
the airflow speeds between the three settings
o Sleep- this mode, represented by “ZZZ”, operates like the Normal/manual
mode, but the airflow speed gradually decreases over a period of 1-2 hours,
and the unit eventually turns itself off. The higher the initial airflow setting,
the longer the unit runs before shutting off, and the greater the different
airflow speeds the unit cycles through prior to shutting off