Silvercrest Z31635 - Manual (Page 13)

13 GB
Removing nose and ear hair
Note: Do not use the product if the blade 2 is deformed or damaged.
Take off the protective cap 1 . Switch the device on by pushing the
ON / OFF switch 3 upwards.
CAUTION! DANGER OF INJURY! Be careful not to insert the
device too deep into nose or ears. Carefully insert only the tip of the
blade into the front area of your nostril or ear. Remove the nose or ear
hair with small circular movements.
After using the trimmer, switch the device off by pushing the ON / OFF
switch downwards.
Cutting eyebrows
Select the long comb attachment 6 or the short comb attachment 7
depending on the desired hair length (“Long” 6 : approx. 7 mm
length; “short” 7 : approx. 4 mm length).
Set the comb attachment on the blade (see fig. C). Ensure that the
comb attachment 6 , 7 fastens audibly and sits tightly.
Switch the appliance on. Move the comb in the opposite direction to
the hair growth, and from the outer tip of the eyebrow towards the
nose (see Fig. D).
To trim hair just above the skin surface, remove the comb attachment 6 ,
7 and guide the blade 2 directly over the skin in the desired area.