Handling and operation, Channel setting, Operating the radio set – Silvercrest KH 2131 User Manual
Page 12
10
Handling and operation
KH 2131
GB
NOTICE
Two signal sources can be connected to the radio transmission set. The
►
signal to be transmitted can be selected with the switch ROOM 1
11
resp.
ROOM 2
12
on the back of the transmitter.
To switch over, for example, the signal source AV1 for a TV connected to
►
the transmitter, place the switch ROOM 1
11
at the position 1 (see Fig.
Connection example Transmitter).
To switch over, for example, the signal source AV2 for a TV connected to
►
the receiver, place the switch ROOM 2
12
at the position 2 (see Fig.
Connection example Transmitter and Connection example Receiver).
Channel setting
You can operate up to four radio transmission sets at one location.
When using multiple radio transmission sets, they must be set to diff erent channels.
The transmitter and receiver of each radio transmission set must be set to the
same channel for a successful transfer.
Select a channel (A/B/C/D) with the channel selector switch
5
on the
transmitter.
Select the same channel with the channel selector switch
17
on the receiver.
Operating the Radio Set
Switch the transmitter on by pressing the On/Off switch
2
.
Switch the signal source on, for example, a DVD player, and, if necessary,
start playback.
Switch the receiver on by pressing the On/Off switch
14
.
Switch the target device on, for example, a TV, and activate the A/V input
to which you have connected the receiver.
The radio transmission should now function.
NOTICE
The device transmits the audio/video signals in the 2.4 GHz frequency
►
range. Take note that, in the 2.4 GHz frequency range, there is no general
protection against listening in or viewing.