Silvercrest SON 90 A1 - Manual (Page 8)

- 6 -
Opening the front flap
Attention!
Always switch the machine off with the power switch 8 when you open
the front flap 0. Risk of Injury!
• Slide the front flap 0 to the right (A) and then pull it towards you (B)
(Fig. 5).You will see the upper looper behind the front flap 0.
Note:
While sewing, the front flap 0 must be kept closed!
Preparation
Place the overlock sewing machine on a stable and level surface.
Ensure there is sufficient illumination at your workplace.
Connecting the foot pedal
• Insert the plug of the foot pedal into the socket for the foot pedal 7.
• Insert the plug into a power socket.
To switch the machine on, press the power switch 8.
Attention!
During absences from the machine or when doing maintenance work,
always remove the plug from the mains power socket. Risk of Injury!
Controlling the sewing speed
The sewing speed is controlled by means of the footpedal. The sewing
speed is changed by applying more or less pressure to the footpedal.
Safety switch
This machine is fitted with a micro safety switch. You cannot start the machine
if the front flap 0 is open. Close the front flap 0 before you start to sew.
Fitting the waste container
The waste container collects remnants during sewing, so that your workplace
stays tidy.
• First push the two restraints (A) into the receiving holes (B) (Fig. 6).
• Then guide the two restraints (C) into the receiving holes (D) (Fig. 7).
• To remove the waste container, pull it forward and then tilt it slightly
(Fig. 8).
Fig. 5
Fig. 8
Fig. 7
Fig. 6
IB_64780_SON 90 A1_LB6 08.03.2011 17:22 Uhr Seite 6