Silvercrest SWKT 3000 A1 - Manual (Page 23)

- 21 -
• Do not allow individuals (including children) to
use the appliance whose physical, sensorial or
mental abilities or lack of experience and know-
ledge hinder their safe usage of it if they have
not previously been supervised or instructed in its
correct usage.
• Tell children about the appliance and its potenti-
al dangers so that they do not play with it.
Starting Up the Device
• Before starting up the device, make certain that...
– the device, plug and power cable are in good
working order and...
– all packaging materials have been removed
from the device.
• Fill the device with water up to the MAX mark
and let it come to a full boil once as described in
the next section. Pour out this water.
Boiling Water

Danger! Never place the electrical base
near water – life-threatening danger!

Warning: Pull the power plug from the
socket before lifting the kettle
u from the
base t . This prevents any water
splashing out from contacting the electrical
connections in the base
t , which could
cause a short circuit.
For safety reasons, the lid q should not
be opened while the water is boiling or is
very hot. Otherwise there is a risk of
injury.
You should only heat as much water as you need
directly. That helps you save electricity, water and
time:
• Lift away the kettle u for filling!
• Open the lid q by pressing down on the unlok-
king button w .
• Hold the kettle u vertically while filling. Only
then will the level indicator i on the side
correctly indicate the water volume.
Fill the kettle u ...
– at least to the MIN mark so that the device does
not overheat,
– no higher than the MAX mark so that no boiling
water spills out.
• First close the lid q ...
• then place the kettle u on the base t until it sits
straight on the base t .
• Set the desired water temperature using the
temperature control y .
To bring the water to a boil, you must set the
temperature controller
y to the MAX position.
• Now insert the power plug into the power
socket and press the ON/OFF switch e down
until it snaps in.
• The operating light r indicates that the device is
now heating up.
Temperature regulator in the boiling range
• The devices switches off automatically and the
operating light r goes out as soon as the water
is at a full boil. The ON/OFF switch e springs
out.
MIN
MAX
ke
ep
wa
rm
ran
ge
bo
ilin
g
ra
ng
e
Transition-
range
IB_56541_SWKT3000A1_LB5 24.08.2010 14:47 Uhr Seite 21