Silvercrest SOML 807 A1 - Manual (Page 72)

Mouse with charging cradle SOML 807 A1
70 - English
After inserting a rechargeable battery into the mouse
or powering the mouse on, the indicator (8) will flash
several times during automatic synchronisation with
the receiver. When the synchronisation is completed,
the status indicator will stop lighting.
The power for charging the battery is obtained from
the computer’s USB port. Depending on your
computer, the USB power may be cut when the
computer is powered off. In this case, you may only
charge the wireless mouse battery when the
computer is powered on.
Connecting the USB Nano Receiver
If you still have your old mouse connected to the computer, please
shut down your computer, disconnect the device from your PC and
restart the computer.
Connect the USB Nano Receiver (12) to a free USB port of your
running computer.
The operating system will automatically recognize the new
hardware and install the required drivers. Depending on the
operating system installed, the following screen messages may
appear:
Windows
®
XP
When the receiver is connected for the first time, the operating
system displays the message „New hardware detected“. Wait
until the message „The new hardware has been installed and is
now ready for use“ is displayed before using your mouse.
Windows Vista
®
, Windows
®
7
When the receiver is connected for the first time, the operating
system displays the message „Installation of appliance driver
software“. Wait until the message „The appliances are ready for
use now“ appears. The mouse is now operational and ready to be
used.