Silvercrest SKD 2300 A1 - Manual (Page 44)

42
Warning! Ensure that there is
sufficient distance from the wall,
fixtures and other appliances. The
distance must be at least 1 m to
exclude the risk of fire.
1. Select a location in compliance with the
safety information (see “4. Safety
information” on page 38).
2. Plug the mains plug into a wall socket
that complies with the technical data.
Note:
If you have plugged other power
consumers into the same circuit, check
that the maximum load for the installed
fuse is not exceeded, as otherwise the
fuse will trip.
5.3 Inserting the batteries
If the appliance is new or the batteries in the
remote control are flat, new type AAA/R03
batteries must be inserted.
1. Push off the battery compartment cover
on the underside of the remote control.
2. Remove the old batteries if present.
Note: Please observe the instructions for
disposal (see “9.2 Disposable/
rechargeable batteries” on page 45).
3. Insert new batteries.
Note: Ensure the correct polarity (+/–).
The correct polarity is shown on the
bottom of the battery compartment.
4. Close the battery compartment again.
6. Operating
6.1 Using the appliance for the first
time
1. Plug the mains plug into a wall socket
that complies with the technical data (see
“3. Technical data” on page 38).
2. Switch the mains switch 9 to ON to
switch on the power supply.
The lamp in the main switch 9 lights up
and you hear a beep.
3. Press the On/Off button 22 to switch the
appliance on.
The display 5 lights up.
The appliance is now ready for use and can
be operated by means of the remote control
or control panel 2.
6.2 Selecting the temperature
Notes:
• Temperature display 20:
– set specified temperature
• Temperature display 21:
– measured actual temperature
• Temperature is measured directly at the
appliance using temperature sensor 8. It
may be some time before the entire
room has also reached this temperature.
1. To choose whether you wish the
temperature to be displayed in °C or °F,
press button 24.
Selected unit of measurement 14 is
shown in the display 5.
2. Press the “Increase temperature” button 16
to increase the desired temperature up to a
maximum of 37 °C (99 °F).
Selected specified temperature 20 is
shown in display 5.
RP74308 Konvektor LB5 Seite 42 Mittwoch, 16. Mai 2012 3:28 15