Silvercrest SZA 28 A1 - Manual (Page 24)

- 22 -
Connection
µ Place the device on a firm and level surface.
Connection to a television
µ Connect the antenna cable of the indoor anten-
na 6 to the antenna socket of your television.
The antenna cable of the indoor antenna 6 can
only be connected directly to the TV if the TV
has a built-in DVB-T Tuner.
Connection as a radio aerial
µ When you want to use the room antenna for
radio reception, utilise the Adapter Coaxial
socket/Coaxial socket
8 .
µ Connect the Adapter Coaxial socket/Coaxial
socket 8 with the antenna cable.
µ Connect the anntenna cable with Adapter
Coaxial socket/Coaxial socket 8 to the
75 Ohm connector on your stereo system.
Connection to a DVB-T receiver
µ Connect the antenna cable of the indoor
antenna 6 to the antenna socket of the DVB-T
Receiver.
µ To connect the room antenna to a DVB-T-
Receiver with an F-socket, the Adapter F-Plug/
Coaxial socket
7 must be used.
µ Connect the Adapter F-Plug/Coaxial socket
7
with the antenna cable.
µ Screw the antenna cable with the Adapter
F-Plug/Coaxial socket 7 to the F-socket of the
DVB-T-Receivers.
Power source connection
µ Insert the power plug of the indoor antenna
into the power socket.
Operating the Indoor Antenna
Receiving programme signals via the
indoor antenna
The programme signals are received by the indoor
antenna and transmitted to the television set.
For the reception of DVB-T transmitter signals you
need a TV with an integrated DVB-T Tuner or an
additional DVB-T Receiver (DVB-T signals are not
available everywhere).
The indoor antenna has to be positioned correctly
for the proper reception of programme signals.
The following antennas are available for this:
1 two telescoping antennas for VHF and UKW
reception that tilt and rotate by 180° and
2 one oval-shaped antenna for UHF reception
that tilts and rotates by 100°.
To orient the indoor antenna:
µ Pull out both telescopic antenna
1
µ and adjust these until the best reception is
obtained.
µ Adjust the oval antenna
2 by turning or tilting
until the best reception is obtained.
Switching On and Regulating the Amplifier
You can regulate the amplifier gain by turning the
regulator
4 on the front of the appliance:
µ Switch on the indoor antenna by turning the
regulator 4 to the right. The operation
indicator 3 glows green.
µ Turn the regulator
4 in clockwise direction to
increase the amplifier gain.
µ Turn the regulator
4 in anti-clockwise direction
to decrease the amplifier gain.
µ Turn the regulator
4 completely to the left
until it clicks to switch off the indoor antenna.
IB_SZA28A1_61184_GB_LB5.qxd 29.11.2010 9:14 Uhr Seite 22