Silvercrest Z31284 - Manual (Page 36)

36 GB/MT
Cutting eyebrows
Select the long comb attachment 6 or the short comb attachment 7
depending on the desired hair length (“Long”: approx. 7 mm length;
“short”: approx. 4 mm length).
Set the comb attachment on the blade (see fig. C). Ensure that the
comb attachment 6 , 7 fastens audibly and sits tightly.
Switch the appliance on. Move the comb in the opposite direction to
the hair growth, and from the outer tip of the eyebrow towards the
nose (see Fig. D).
To trim hair just above the skin surface, remove the comb attachment 6 ,
7 and guide the blade 2 directly over the skin in the desired area.
Note: To trim only individual hairs, adjust the angle of the blade and
guide this against the individual hairs.
Cleaning, care and storage
Note: Always switch off the product before cleaning it.
Do not use any corrosive or abrasive cleaning agents. These might
damage the surface of the product.
Clean the housing with a dry cloth.
Take off the comb attachment
6 , 7 and clean the blade 2 care-
fully under running water as shown in Fig. E. Then fully dry the comb
attachment before re-installation.