Silvercrest SDRB 1000 A1 - Manual (Page 11)

- 9 -
• Should the heating-up control lamp 5 start to glow
during the process, release the steam blast button 8
and wait a few seconds until the heating-up control
lamp 5 extinguishes.
Note:
Should you press the steam blast button 8 whilst
the heating-up control lamp 5 is glowing the result
will be condensed water instead of steam, and water
will drip from the sole of the iron 0.
• Leave the garment on the clothes hanger to cool
down before putting it on.
Curtain and soft furnishing care
• Creases and wrinkles can be removed from
draperies by hanging them over a pole.
• Then simply follow the directions given under
“Clothing care”.
• Always carry out a test first at a concealed part.
• If you are using the appliance horizontally, every
now and then hold it upright so as to have the
maximum steam performance.
Fluff brush
• Threads, fluff and hairs can be easily removed
with the red fluff brush e by slowly brushing
over the garment with it from left to right.
• You can clean the fluff brush e by brushing with
it in the opposite direction (from right to left)
over, for example, a remnant of material.
Ironing function
• Dismantle the brush attachment w from the
appliance (see “Attaching/detaching the brush
attachment”).
• Connect the appliance to a correctly installed
and earthed mains power socket.
• Adjust the temperature regulator 3 as per the
international point symbols (Care Label) or the
type of material. The heating-up control lamp 5
glows. As soon as the set temperature has been re-
ached, the heating-up control lamp 5 goes out .
Note:
If doubt exists, start with a low temperature and
gradually increase it to a higher one. With sensitive
materials we recommend carrying out an ironing
test at a concealed part (inside seam).
• For heavily creased laundry, you can use the
steam function by pressing the steam shot button
8. To generate the steam, the temperature regu-
lator 3 must be set to at least ••• or higher.
• Should the heating-up control lamp 5 glow during
the process, release the steam blast button 8
and wait for a few moments until the heating-up
control lamp 5 extinguishes.
• You can repeatedly press the steam blast button
8 until the heating-up control lamp 5 glows or
water drips from the sole of the iron 0. Then,
wait until the heating-up control lamp 5 extin-
guishes before activating a further blast of
steam.
Note:
Should you press the steam blast button 8 whilst
the heating-up control lamp 5 is glowing the result
will be condensed water instead of steam, and water
will drip from the sole of the iron 0.
Should the water tank 1 become empty while the
appliance is in use, remove the plug 7 from the
power socket before refilling it.
Washing label Type of material Temperature
regulator 3
Chemical fibres,
e.g. viscose,
polyester
•
(low
temperature)
Silk, Wool
••
(medium
temperature)
Cotton, Linen
•••
(high
temperature)
IB_68982_SDRB1000A1_LB4 17.08.2011 11:39 Uhr Seite 9