Silvercrest SUR 46 A1 - Manual (Page 78)

78 GB/MT
Operation
1. Close the cover 5 and insert the mains plug 12 .
The figure 180
3 Min
(180 seconds) appears in the display 2 as stand-
ard – this is the standard time for a normal degree of soiling.
2. Select the desired time from five possible intervals:
(
180
g
300
g
480
g
090
g
600
). Use the timer button 4 to
set the desired time according to the degree of soiling.
3. Press the On-switch 1 and start the cleaning process.
The blue indicator light 6 on the lid 5 illuminates while the time
in the display 2 counts down to 0.
Note: During the cleaning process a quiet vibration noise can be
heard; this is caused by the cleaning process.
4. After the set time has elapsed the cleaning process is automatically
stopped, the blue indicator lamp 6 goes off and the display 2
shows
000
. The originally selected time interval in minutes/sym-
bol remains visible.
5. Press the Off-switch 3 to stop the cleaning process prematurely if
necessary. The time remaining from the selected time interval is
shown on the display
2 . Press the On-switch 1 again to resume
the cleaning process 1 . Or select a new time interval using the
timer button 4 and press the On-switch 1 again.
m
Important! You can repeat the cleaning process in order to
intensify the cleaning effect.
If the cleaning process is started several the liquid becomes very
warm (approx. 41°C after the first cleaning process and approx.
60°C after the third in spite of a five-minute cooling down phase).
However, it is recommended that between the cleaning processes
a pause of at least five minutes is inserted in order to allow the de-
vice to cool down. Do not change the time interval while a cleaning
process is still running. Allow the time interval to expire normally,
thus ensuring that the cleaning process is properly time-controlled.
6. If you wish to repeat the cleaning process, press the timer button 4 .
The next timing program appears on the display 2 .