Silvercrest STK 650 A1 - Manual (Page 29)

- 27 -
Items supplied
Tea Automat
Cleaning brush
Riser tube brush
Operating instructions
Technical data
Power consumption : 550-650 W
Mains voltage: 220-240 V ~ 50 Hz
Appliance description
1 Lid
2 Grip
3 Glass pot
4 Control lamp
5 Base
6 Reset button
7 Power cable
8 On/Off switch
9 Cleaning brush
0 Riser tube brush
q Brew chamber
w Water riser tube
e Sieve
Before the First Use
• Remove all packaging materials from the appli-
ance.
• Carefully rinse all parts of the brewing system
(brew chamber q, water riser pipe w, Sieve e)
and the glass pot 3 (see chapter “Cleaning
and Care”).
Proceed as follows before the first usage:
1. Remove the glass pot 3 from the base 5.
2. Fill the glass pot 3 up to the MAX marking with
water, then add a teaspoon of lemon juice (or le-
mon concentrate) to it. If lemon juice is not avai-
lable, you could add a teabag (or a teaspoon of
loose tea) directly into the water.
3. Replace the brew system in the glass pot 3.
4. Close the lid 1 and replace the glass pot 3 on
the base 5.
5. Switch the appliance on with the On/Off switch 8.
The control lamp 4 and the On/Off switch 8
light up. Wait until the control lamp 4 goes out.
6. Switch the appliance off with the On/Off switch 8
and then clean the appliance as described in
“Cleaning and Care”.
The Tea Automat is now ready for use.
Operation
Warning:
DO NOT put any sugar into the Tea Automat. DO
NOT heat milk or alcohol in the tea automat. This
would irreparably damage the appliance.
Note:
Green tea is not suitable for brewing in the Tea
Automat. The ideal brewing temperature for green teas
lies at around 70°C. At higher brewing temperatures,
such as those generated in the Tea Automat, tannic
acids are released. The tea will taste bitter.
1. Remove the glass pot 3 from the base 5.
2. Open the lid 1 and take out the brew system.
Place the brew system on a level and even surface.
IB_66500_STK650A1_LB5 31.05.2011 10:14 Uhr Seite 27