Silvercrest SFR 1200 A1 - Manual (Page 12)

12 GB/IE
Disposal / Warranty and service
This is how you can disassemble your
appliance to ensure environmentally
friendly disposal of it:
First disconnect the shaver from the AC adaptor
plug.
Remove the decorative strips on the side; lever
the upper cover plate off with a screwdriver or
similar.
Unscrew the 4 screws with a Phillips screwdriver
(see Fig. B).
Disassemble the two halves of the casing with
a screwdriver or similar (see Fig. C).
Separate the batteries and the trimmer or similar
components from the printed circuit board and
the motor (see Figs. D, E). Dispose of the parts
separately.
Warranty and service
The Service Hotline for your country is
shown on the enclosed warranty docu-
mentation.
Extreme care was used in the manufacture of our
product. Therefore we are able to provide a warranty
for the defect-free condition and functioning of the
product within the provisions of our warranty terms
and conditions. However, should a fault develop,
we will rectify all defects that are attributable to
faults in materials or manufacture.
The period of warranty is 36 months and begins on
the day of purchase. The performance of a service
under the warranty does not extend or renew the
warranty period. Please retain the sales voucher as
proof of the purchase date. Your warranty rights
under law are not limited by this warranty.
The following types of damage and items are not
covered by the warranty:
– wear parts such as foils
4 and cutter set 12 ,
– parts that undergo wear naturally or as a conse-
quence of use,
– damage to fragile components,
– damage caused by unauthorised interference.
– damage caused by the use of non-original replace-
ment parts,
– damage caused by improper handling,
– damage caused by force majeure,
– damage caused by non-observance of the
maintenance advice,
– single-use and rechargeable batteries.
Similarly we cannot accept liability for the conse-
quences of improper use of the device.
Procedure in the case of warranty
In order to ensure quick processing of your request,
please follow the instructions below:
• Please have your receipt and the product number
(e.g. IAN 12345) available for any queries and
as proof of purchase.
• Please take the product number from the type
plate engraving, from the title page of your
instructions (bottom left) or from the label on the
rear side or underside.
• Should functional faults or other defects arise,
first contact the service department by phone.
• You can send a product, which has first been
registered as defective, postage free to the
address given to you by the service department,
enclosing the purchase slip (receipt) and written
details of the fault and the date it occurred.
Tel: 00800 36 46 36 00 (0.00 EUR / Min.)
IAN 74435