Silvercrest SZP 25 B1 - Manual (Page 32)

30 GB
3. As soon as you stop pressing on the
juicer cone2/3, the device stops.
4. If the juicer cone2/3 is not turning,
check if there are pips between the juic-
er cone and the screen4/5 and re-
move them, if necessary.
5.3 Removing the juice
CAUTION: pull out the mains plug9 be-
fore removing the juice container7 from the
base10.
1. Figure B: turn the juice container7
counterclockwise and lift it from the
base10.
2. Pour the juice out of the juice container7.
3. In order to remove pulp and pips, you
can remove the screens4/5 and the
juicer cone2/3 together with the juice
container7.
4. Clean the device after each use as soon
as possible so the pulp does not start
drying to the surface.
6. Cleaning
Clean the device prior to its first use!
DANGER! Risk of electric
shock!
• Pull out the mains plug9 from the wall
socket before cleaning the citrus press.
• The base10, the power cable and the
mains plug9 must not be immersed in
water or any other liquids.
WARNING!
• Do not clean the citrus press or any of
its accessories in the dishwasher or with
boiling hot water.
• Do not use any astringent or abrasive
cleaning agents.
NOTE: clean the device after each use as
soon as possible so the pulp does not start
drying to the surface.
1. Remove the lid1, if necessary.
2. Remove the juicer cones2/3 and disas-
semble them.
3. Remove the screens4/5.
4. Figure A: in order to disassemble the
screens4/5, exert slight pressure on
the screen opener6.
5. Figure B: turn the juice container7
counterclockwise and lift it from the
base10.
6. Wipe the base10 with a damp cloth.
7. Wash up all removable accessories by
hand. Make sure to wash the small cavi-
ty in the handle with a sufficient amount
of clear water.
8. Dry all parts carefully, before reassem-
bling the device and storing it.
7. Storage
1. You can wind up the power cable9 in
the cable wrap11.
2. Place the lid1 on the device as a pro-
tection against dust. Ensure that the re-
cess in the edge of the lid is above the
handle.
8. Disposal
The symbol showing a wheel-
ie bin crossed through indi-
cates that the product requires
separate refuse collection in
the European Union. This ap-
plies to the product and all ac-
cessories marked with this
symbol. Products identified with this symbol
may not be discarded with normal house-
hold waste, but must be taken to a collection
point for recycling electric and electronic ap-
pliances. Recycling helps to reduce the con-
sumption of raw materials and protect the
environment.
__RP77146_B5.book Seite 30 Freitag, 21. September 2012 2:01 14