Silvercrest SHBS 600 A1 - Manual (Page 54)

52 GB
6. Cleaning and care
DANGER! Risk of electric shock!
Pull the power unit out of the wall socket before you clean the device.
WARNING! Risk of injury!
Always switch off the device before cleaning it.
WARNING! Risk of material damage!
•
The blades2 of the shaving head9 may only be cleaned with medical al-
cohol. Do not use any water or other liquids. Oil the blades as described in
the following chapter.
• Do not use any astringent or abrasive cleaning agents.
NOTE: Clean and oil the device after every use.
• Remove the comb attachment1. Rinse the comb attachment with water and
let it dry before reattaching it to the device.
• Wipe down the housing of the device with a damp cloth.
Cleaning and oiling the shaving head
1. Figure D: remove the shaving head9 from the device by pressing it with
the thumb towards the rear.
2. Remove the hair remnants from the shaving head by using the cleaning
brush included in the delivery.
3. Clean the blades2 of the shaving head9 with medical alcohol (not sup-
plied). Do not use any water or other liquids. Let dry the shaving head.
4. Apply a few drops of the supplied oil to the blades2 of the shaving
head9 and spread it out evenly. Using a soft cloth, wipe off the surplus oil,
if necessary. Only use acid-free oil, such as e.g. sewing machine oil.
5. Figure E: guide the lug of the shaving head9 under the edge of the hous-
ing and press the shaving head downwards onto the blades until it is heard
to lock in place.
__GRA78917_B5.book Seite 52 Freitag, 7. September 2012 1:35 13