Silvercrest SMP 6200 A1 - Manual (Page 11)

9 SMP 6200 A1
GB
WARNING - RISK OF INJURY
At too high speeds and with a too heavy pressure, the sapphire
miller can quickly penetrate into deeper, healthy skin layers.
This can cause injury and damage to the periosteum!
Always take care and a cautious approach when removing corns. If in ►
doubt, consult a pedicurist, podolgist or a dermatologist.
To remove corns, mill very carefully and slowly at low speed with the round
sapphire cutter w.
Under no circumstance should you use undue pressure, otherwise you could
rapidly penetrate healthy skin and injure it.
Working with the appliance
WARNING - RISK OF INJURY
Too long and too intensive treatment can also injure deeper
layers of skin.
Therefore regularly check the treatment progress and results. Diabetics ►
in particular are less sensitive on the hands and feet.
NOTICE
The attachments show only a reduced eff ect with softened skin. Therefore do ►
not carry out any pretreatment in a water bath before using the appliance.
Find a well-lit place to work. A mains power outlet must be posi- 1)
tioned in close proximity.
Insert the appropriate attachment for your purpose in the attach- 2)
ment acceptor 1. The attachment must sit securely.
Insert the power adapter 3) 4 into a mains power outlet.
Slide the on/off /direction switch 4) 6 into the desired direction.
The appliance runs with the lowest speed.
NOTICE
Always select the direction of run so that you can treat the nails in their ►
direction of growth. Where possible, treat the nails from the outside to-
wards the inside (to the nail tip). Otherwise, the nails split more easily.
If you feel that the nails could tear during treatment, select the other
►
direction of run.
IB_46740_SMP6200A1_LB4 9 IB_46740_SMP6200A1_LB4 9 06.12.2011 10:50:21 Uhr 06.12.2011 10:50:21 Uhr