Silvercrest SDBK 2400 C2 - Manual (Page 13)

11 GB
9. Storage
DANGER!
Store the steam iron out of the reach
of children.
1. Set the temperature controller 20 to
MIN.
2. Place the iron on the stand 13 and set
the switch 12 to the middle position .
3. Allow the device to cool down.
4. Set the steam flow rate controller 3 to
.
5. Set the switch 12 to the upper position
.
6. Remove the iron from the stand 13 and
pour off any remaining water through
the filling opening of the water tank (un-
der the lid 2).
7. Place the iron on the stand 13 and set
the switch 12 to the middle position .
8. Figure E: coil up the power cable in
the base of the stand.
9. Store the iron and the stand 13 in an
upright position.
10. Disposal
The symbol showing a
wheelie bin crossed through
indicates that the product re-
quires separate refuse collec-
tion in the European Union.
This applies to the product
and all accessories marked
with this symbol. Products identified with this
symbol may not be discarded with normal
household waste, but must be taken to a col-
lection point for recycling electric and elec-
tronic appliances. Recycling helps to reduce
the consumption of raw materials and pro-
tect the environment.
Packaging
When disposing of the packaging, make
sure you comply with the environmental reg-
ulations applicable in your country.
11. Trouble-shooting
If your device fails to function as required,
please try this checklist first. Perhaps there is
only a minor problem, and you can solve it
yourself.
DANGER! Risk of electric
shock! Do not attempt to repair the
device yourself under any
circumstances.
Fault Possible causes/Action
No
function
• Connect the device to the
mains power supply.
• Use the temperature control-
ler 20 to turn up the temper-
ature.
Little or
no steam
• Fill the water tank 17 to at
least one quarter full.
• Switch on the steam flow
rate controller 3
(
).
• Run the self-cleaning cycle.
Steam
burst is
not work-
ing.
• Fill the water tank 17 to at
least one quarter full.
• Set the right temperature.
• Leave a pause of a few sec-
onds between steam bursts.
Spray
burst is
not work-
ing. • Fill the water tank 17 to at
least one quarter full.
• For the first spray burst, you
need to pump several times.
__RP37102_Dampfbügeleisen_B3.book Seite 11 Montag, 2. September 2013 8:00 20