Silvercrest SIKP 2000 B1 - Manual (Page 9)

7 GB
DANGER! Risk of injury
through burning!
Do not touch the surface of an induc-
tion hot plate, on which a cooking
vessel has been used beforehand.
The temperature of the surface can
still be very high after a cooking ves-
sel has been removed.
8.1 Switching on
1. Place the cooking vessel in the middle
of the cooking zone2.
2. Insert the mains plug1 into a wall sock-
et corresponding to the specifications of
the rating plate. An acoustic signal
sounds. At the same time, the display
and control lights are activated shortly
so they can be checked for proper func-
tioning.
The display shows...
…
- L -, if the temperature of the cooking
zone is less than 60 °C and
… - H -, if the temperature of the cook-
ing zone is more than 60 °C.
3. Switch on the appliance by touching the
symbol on/off 5.
The control light on/off4 lights up.
The control light12 over the symbol
10 flashes.
W (watt) flashes over the display and
on the display you can see the chosen
power setting (presetting: 1000 watt).
NOTE: if you do not initiate any chang-
es within approx. 30 seconds by touch-
ing the symbols 7/ 8, the appli-
ance switches off automatically.
4. Change the heat output by touching the
symbols 7/ 8 in steps of 200watt
from 200 - 2000 watt. The heating
phase begins immediately after you
have touched one of the two symbols.
The higher the chosen power, the quick-
er the base of the cooking vessel is heat-
ed up.
By touching the symbols 10, the dis-
play image changes from
W (watt)
to °C. You can now choose the desired
setting also as a temperature specifica-
tion in steps of 20 °C from 60 - 240 °C
(presetting: 120 °C). After the tempera-
ture has been achieved, it is kept at the
specified value.
You can change specified settings at
any time during operation.
You can also touch the symbols uninter-
ruptedly to change the settings.
8.2 Switching off
• Touch the symbol on/off 5, to switch
off the appliance. An acoustic signal
sounds. The symbol
-H- is shown in the
display, as the temperature of the cook-
ing zone is more than 60 °C. The cool-
ing fan carries on cooling the appliance
after it has been switched off.
• The appliance automatically stops the
heat output if the cooking vessel is re-
moved from the cooking zone2 during
the heating phase. The error message
E1 is shown in the display and an
acoustic signal sounds. If you do not
place the cooking vessel on the hot
place within approx. 10 seconds, the
appliance switches off. The cooling fan
carries on cooling the appliance after it
has been switched off.
• After 120 minutes without a change in
setting, the appliance switches off auto-
matically. The cooling fan carries on
cooling the appliance after it has been
switched off.
__RP90248_B4.book Seite 7 Montag, 4. März 2013 9:39 09