Silvercrest SHBS 1000 A1 - Manual (Page 11)

8 SHBS 1000 B1
GB
Operation with the power supply unit
If your hair and beard trimmer stops working during shaving due to discharged
or weak batteries, you can continue shaving by plugging in the power supply
unit
6 .
♦ Plug the power supply unit plug 6 into the socket on the underside of the hair
and beard trimmer.
♦ To avoid injuries and damage to the appliance, always switch the appliance off
before connecting it to the power supply.
♦ Plug the power supply unit 6 (wide voltage range 100 - 240 V) in a power
socket complying with the appliance specifi cations.
♦ After 1 - 2 seconds, you can switch the appliance on by pressing the ON / OFF
switch
3 . If the appliance does not start immediately, switch it off again and
wait around 1 minute before switching it on again.
♦ If you want to charge the batteries without using the charging station 5 in this
manner you can only do this when the appliance is switched off .
Handling and use
Improving battery service life
We recommend completely discharging the batteries before recharging to ensure
a long battery service life. In order to completely discharge the batteries, run the
appliance until it stops completely.
Cutting hair
NOTE
► Any hair to be cut should be clean and dry.
► Brush the hair carefully through to remove any knots.
► Place the hairdressing cape or cloth around your neck and throat to avoid
cut hair ends falling inside your collar.
► First start using a longer cut length add-on 7 and then shorten your hair in
stages until it has the required length.
IB_31711_SHBS1000B1_LB4.indb 8 IB_31711_SHBS1000B1_LB4.indb 8 03.02.14 08:15 03.02.14 08:15