Silvercrest Electrical Sockets - Manual (Page 7)

7 GB/IE/CY
Introduction / Safety / Setting up
thus get an electric shock. Nevertheless,
please keep the device out of the reach
of children at all times.
Q
Safety
Safety advice
Read these operating instructions and
safety advice carefully. Look at the dia-
gram page and familiarise yourself with
all functions of the device before start-
ing it up for the first time.
Avoid danger to life from elec-
tric shock!
J Only connect the radio-controlled
sockets to earthed 240 V~ domestic
sockets.
J At all costs, avoid exposure to damp
and extreme temperatures.
J Only use the radio-controlled sockets
in enclosed spaces. They are not
suitable for outdoor use.
J Despite the child protection socket
8 , please keep the device out of
the reach of children at all times.
J Avoid overloading the device.
Overloading can cause a fire hazard
or damage to the device. The maxi-
mum capacity is approx. 3.000 W
per radio-controlled socket.
J Please contact the service department
immediately operational faults arise.
J Do not open the device on any ac-
count. All necessary repairs should
only be carried out by the service
department or a specialist electrical
workshop.
J Before cleaning always disconnect
the device from the mains supply. In
this case always remove the ra-
dio-controlled electrical outlet sock-
et from the mains wall socket and
remove all plugs from the device.
J Do not have one radio-controlled
electrical outlet socket inserted
behind the other.
J Do not use any additional child
protection devices for the radio-
controlled sockets. The connection
between the plug and the radio-
controlled socket could be impaired
and risk from overheating then arises.
The radio-controlled sockets already
have a child protection device which
prevents children from putting any
objects into the socket.
J Make sure that the connected
radio-controlled electrical outlet
sockets are freely accessible and not
covered by other objects.
J If the device malfunctions, switch it
off immediately.
J These instructions are a component
of the device. If you pass the device
on to a third party, these instructions
must also be handed on.
Q
Setting up
Q
Preparing the remote
control (fig. A)
1. Open the battery compartment on
the back of the remote control by