Electrolux 2972-6 i - Manual (Page 20)

20
Installation Location
The appliance should be set up in a well ventilated, dry room.
Energy use is affected by the ambient temperature. The appliance
should therefore
Ð not be exposed to direct sunlight;
Ð not be installed next to radiators or other sources of continuous
heat;
Ð only be installed at a location whose ambient temperature corre-
sponds to the climate classification, for which the appliance is desi-
gned.
The climate classification can be found on the rating plate, which is
located at the left on the inside of the appliance.
The following table shows which ambient temperature is correct for
each climate classification:
Climate classification for an ambient temperature of
SN +10 to +32 ¡C
N +16 to +32 ¡C
Your appliance needs air
For safety reasons, minimum venti-
lation must be as shown Fig.
Attention: keep ventilation ope-
nings clear of obstruction;
50 mm
min.
cm 2 200
200 cm
2
min.
D567
Reversing the door
The side the door opens can be changed from the right side (factory
adjustment) to the left side, if the installation site requires.
Warning! When changing the side the door opens, the appliance
must not be connected to the mains. Remove plug from the mains
beforehand.