Silvercrest Z31183 - Manual (Page 47)

47 GB/MT
In the metric system:
– Millimetre (ml) water:
“WATER” is shown in the
LC display.
– Millimetre (ml) milk: “MILK” is shown in the
LC display.
In the imperial / avoirdupois system:
– Fluid ounces (fl. oz) water: “WATER” is shown in the
LC display.
– Fluid ounces (fl. oz) milk: “MILK” is shown in the
LC display.
Press the ON / OFF button 3 . The appliance is now in
weighing mode. The set unit of weight appears under to
the right of the weight in the LC display
5 .
Press and hold the ▼ UNIT button 6 for about 2 seconds
to change the unit of weight (g / lb’oz).
The weight “0” is shown in the LC display. Place a suitable
bowl or container on the balance tray 2 and press the
▲ Z / T button 7 . Again, the weight “0” is shown in
the LC display. The weight of the bowl / container is not
displayed.
Place the product to be weighed in the bowl / container.
The weight of the product is shown in the LC display.
Note: If no button is pressed for 2 minutes, or the weight
is not changed, the readout in the LC display always returns
to the time mode.
Tare (TARE function)
You can set the appliance to “0” again, so that you can weigh
out another product.
Note: A small circle-symbol appears in the left of the LC display
as soon as the appliance is switched on. The display is now in
the standard zero-setting. The circle-symbol disappears as
soon as the TARE function is used.
To do this press the ▲ Z / T button 7 once. The message
“TARE” appears in the LC display 5 . Again, the weight
“0” is shown in the LC display.
Place the next product to be weighed in the bowl / container.
The weight of the newly added product is shown in the
LC display.
Note: You can repeat this process many times. Never
place more than 5 kg onto the appliance.
Remove the bowl / container and the weighed product
from the balance tray. Press the ▲ Z / T button. Again, the
weight “0” is shown in the LC display.
Removing weighed product
Press the ▲ Z / T button 7 . The message “TARE” appears
in the LC display 5 . Again, the weight “0” is shown in
the LC display.
Remove the desired amount of the weighed product.
The weight of the product is shown in the LC display as
a negative value.
Note: You can repeat this process many times.
Remove the bowl / container and the weighed product
from the balance tray. Press the ▲ Z / T button. Again,
the weight “0” is shown in the LC display.
Setting the timer
The timer can be used in the clock and weighing modes. Set
the timer for a defined time period. A signal sounds at the end
of the period. The set time runs as a countdown.