Silvercrest Z31183 - Manual (Page 8)

8 GB
As soon as the batteries have been inserted, the hour display
begins to flash. To set the hour press the ▲ Z / T button 7
or the ▼ UNIT button 6 .
Press the T-SET button 4 , to go to the minute display.
Press the ▲ Z / T button or ▼ UNIT button to set the minutes.
Press the T-SET button. The clock is now set.
Note: If you need to reset the time, press and hold the
T-SET button until the time display flashes. Proceed as
described above.
Setting up the appliance
Place the appliance on a flat, non-slip surface.
Note: Because furniture surfaces are made of a variety
of materials and treated with very different products, it
cannot be ruled out that some of these materials may
contain chemicals that will attack and soften the rubber
feet. If necessary, place an anti-slip mat under the feet of
the appliance.
Note: Remove the protective film from the balance tray 2 .
Operation
Setting the units of weight and
weighing
You can choose between metric and imperial / avoirdupois units
of weight. For the range 0 g–999 g, the unit of weight is in g;
from 0 oz–15.9 oz, the unit of weight is shown in oz. For the
range from 1000 g upwards, the unit of weight is in kg; from
16 oz the unit of weight is shown in lb:oz. Likewise, you can
weigh liquids, in which case press the ▼ UNIT button
6 .
Keep batteries away from children; do not throw them in
the fire, short-circuit them or take them apart.
If the above instructions are not complied with, the batteries
may discharge themselves beyond their minimum voltage.
There is then a danger of leaking. If the batteries have
leaked inside your appliance, you should remove them
immediately in order to prevent damage to the appliance!
Avoid contact with the skin, eyes and mucous membranes.
Any parts of the body coming into contact with battery
acid should be rinsed off with copious amounts of water
and / or contact a doctor!
Before use
Inserting / replacing the batteries
Note: Always switch off the appliance before changing
the battery.
Remove the battery compartment cover 8 from the
back of the appliance.
If necessary, remove the spent batteries.
Insert 2 x 1.5 V AAA batteries into the battery
compartment 9 .
Note: Ensure the correct polarity. This is shown inside
the battery compartment.
Close the battery compartment again.
The appliance is now in the time mode, and ready for use.
Adjusting the time
The clock must be adjusted before using for the first time and
after the batteries have been changed.