Silvercrest SWCD 1000 A1 - Manual (Page 45)

43 SWCD 1000 A1
GB
Attachment fi tting / removal
WARNING! RISK OF INJURY!
► After operation, the appliance components may be hot!
Fitting Attachments
■ Insert the desired attachment into the attachment insertion slot 1, so that
the front arrow symbol on the attachment points at the arrow symbol on the
attachment insertion slot 1
.
■ Turn the attachment clockwise until it clicks into place. The back arrow on
the attachment now points at the arrow on the attachment insertion slot 1
.
Removing attachments
■ First switch the appliance off and allow it to cool down..
■ Press the release button “push” 7 and turn the attachment anti-clockwise
.
■ The attachment can now be removed by pulling it out of the attachment inser-
tion slot 1.
Switching on/off / Selecting a heat level
■ When you have inserted the required attachment and connected the plug
with the mains power socket, you can now switch the appliance on with the
level switch 3 and select the output level:
– “0“ The appliance is switched off
– “1“ for a reduced air-fl ow strength with heat
– “2“ for a high air-fl ow strength with heat
■ You switch the appliance off by sliding the level switch 3 to the position “0”
(= appliance off ).
■ To fi x the styling, you can use the slide switch Cool Shot 2. The styling will
be fi xed by the cool air stream:
– During operation, slide the slide switch Cool Shot 2 upwards.
The air fl ow will be cooler.
– When you want to deactivate the cool air stream, slide the slide switch
Cool Shot 2 downwards.
IB_72216_SWCD1000A1_LB2.indb Abs2:43 IB_72216_SWCD1000A1_LB2.indb Abs2:43 02.03.12 09:34 02.03.12 09:34