Silvercrest Z31131 - Manual (Page 11)

11 GB
Preparing the product for use / Cleaning, care and storage
Switch the device on by pushing the ON / OFF switch 6 upwards.
Carefully insert only the tip of the nose and ear hair trimmer attachment
into the front area of your nostril or ear. Remove the nose or ear hair
with small circular movements.
After using the trimmer, switch the device off by pushing the ON / OFF
switch downwards.
Cleaning, care and storage
Note: Always switch off the product before cleaning it.
Do not use any corrosive or abrasive cleaning agents. These might
damage the surface of the product.
Take the nose and ear hair trimmer attachment 3 off and clean it
carefully under running water as shown in Fig. C. Then fully dry the
nose and ear hair trimmer attachment before re-installation.
Attention: The product is only protected against splash water. Never
immerse it in water. Otherwise, irreparable damage may result.
If there are still hairs in the the nose and ear hair trimmer attachment,
clean it with the a soft brush.
Occasionally place one or two drops of oil onto the blade 4 and
distribute the oil evenly (see Fig. D).
Only use an acid-free oil suitable for electric razor appliances.
To store the device, always put on the protective cap
1 .
Keep the device in a cool, dry location.