Extron electronic Dual Link DVI Transmitter and Receiver DVI DL 201 Tx - Manual (Page 6)

DVI DL 201 Tx/Rx • Quick Start Guide
Quick Start Guide — DVI DL 201 Tx/Rx, cont’d
QS-2
To use DDC pass-through routed to the local monitor:
a . Configure the DDC switches as shown in the figure
at right and described on page 3-4.
b . Connect a source device to the transmitter.
c . Connect a display device to the receiver and, if
required, a local monitor to the transmitter.
d . Connect the transmitter and receiver.
e . Power on the transmitter, receiver, and local
monitor.
f . Power on the source device.
g . Power on the display device.
To use DDC pass-through routed to the remote display:
Configure the DDC switches as shown in the figure a.
at right and described on page 3-5.
Connect a source device to the transmitter. b.
Connect a display device to the receiver and, if c.
required, a local monitor to the transmitter.
Connect the transmitter and receiver. d.
Power on the transmitter, receiver, and display e.
devices.
Power on the source device. f.
N If there are any problems, consult the troubleshooting section
(page 3-6).
12V
0.4A MA
X PO WE R
DVI-D INPUT
RS-232 PA SS-TH RU
DO NO
T
CONNECT OUTPUT
S
TO LA N
DDC RO UT E
REMO TE
SP ARE
LOCAL
LOCAL OUTPUT
OUTPUT
OUTPUT
1
2
3
PC with Dual Link
DVI Output
Local Monitor
DVI Dual Link
Extron
DVI DL 201 Tx
DVI Dual Link
Transmitter
Extron
DVI DL 201 Rx
DVI Dual Link
Receiver
DV I DL 20
1 Rx
RS-232
PA SS TH RU
Tx Rx
DV I-D OUTPUT
High Resolution
Projector with
Dual Link Input
Twisted Pair
Cables (3) 100’
DVI DL 201 Rx SERIE
S
DVI-D OUTPUT
Tx Rx
CO NT RO L
PAS S T HR U
ON
1 2 3
ON
OFF
DEF
AUL
T EDID
EDID MINDER REMOTE DDC
ON
1 2 3
ON
OFF
DEF
AUL
T EDID
EDID MINDER REMOTE DDC