Extron electronic Dual Link DVI Transmitter and Receiver DVI DL 201 Tx - Manual (Page 24)

DVI DL 201 Tx/Rx • Installation
Installation, cont’d
2-12
Cable Connections and Switches
DVI-D input
Connect the DVI-D source device to the female DVI-I input
connector.
The dual link DVI-D input carries a signal with a resolution up
to 2560x1600 @ 60 Hz.
For sources providing HDMI signals, use an HDMI to DVI
adapter, such as the Extron HDMIF-DVIDM female HDMI to
male DVI-D adapter (PN 26-616-01). The pin assignments for
the DVI-I input connectors are shown in the table on the next
page.
DVI-D output
Connect the local display device to the female DVI-I output
connector on the rear panel of the transmitter and the remote
display device to the output connector on the front panel of the
receiver.
The dual link DVI-D output carries a signal with a resolution up
to 2560x1600 @ 60 Hz.
The pin assignments for the DVI-I output connectors are the
same as those for the input connectors and are shown in the
table on the next page.
N Although DVI-I connectors are used, the DVI DL 201 is
compatible only with DVI-D signals.