Silvercrest SHBS 1000 A1 - Manual (Page 92)

92 GB
Connect the cable of the plug-in mains adapter to the charging
station
5 of the hair and beard clippers.
Avoid injury and damage to the device! Make sure that the
device is switched off before you charge the rechargeable batteries.
Insert the plug-in mains adapter (wide voltage range 100 - 240 V)
into a mains outlet socket that meets the requirements of the device.
The charge state indicator 4 on the front of the device illuminates
red and shows the battery symbol (the symbol indicating that the
device is connected to the mains) and the value indicating the % of
the full charge achieved. After a charge state of approx. 20 % has
been achieved, the charge state indicator
4 changes colour to blue
and the relevant % value for the charge capacity flashes until that
charge state is achieved. The rechargeable batteries are fully charged
when the 100 % mark stops flashing and is continuously illuminated.
The charge state indicator 4 switches off a few seconds after
completion of the charging process.
The device can operate with fully charged batteries for up to
about 60 minutes when disconnected from the mains.
Operation with the plug-in mains adapter:
If your hair and beard clippers stop during use because of discharged
or weak rechargeable batteries, you can continue by connecting the
plug-in mains adapter.
Insert the connector plug of the plug-in mains adapter into the
socket on the underside of the hair and beard clippers.
To avoid injury and damage to the device, always switch off the
device before you connect it to the mains supply.
Insert the plug-in mains adapter (wide voltage range 100 - 240 V)
into a mains outlet socket that meets the requirements of the device.
After 1 - 2 seconds you can switch on the device by pressing the
ON / OFF switch
3 . If the device does not start working immedi-
Before first use / use Before first use