Disassembly of the juice extractor, Cleaning and care – Silvercrest SFE 450 C1 User Manual

Page 10

Advertising
background image

- 7 -

Disassembly of the juice extractor

If you wish to disassemble the juice extractor, e.g.
to clean it, proceed as follows:
1. Remove the power cable with plug

i

from the

wall socket.

2. Open the clasps

r

.

3. Remove the housing lid

e

with the stodger

q

.

4. Carefully lift up the juice container

t

. With this,

the filter

d

releases itself from the drive shaft

f

.

You can now take the filter

d

out of the juice

container

t

.

Cleaning and Care

Warning:

ALWAYS remove the power plug from the wall sok-
ket before removing or installing accessories and
before cleaning the appliance. To avoid blockage
of the juice outlet and/or damage to the appliance,
all appliance and ancillary parts must be regularly,
and after every use, cleaned free of fruit pulp and
vegetable mash.

Note:

DO NOT use any aggressive cleaning agents to
clean the juice extractor. The appliance and its
ancillaries may not be cleaned in boiling water.

Warning:

To avoid receiving an electrical shock, NEVER
submerse the motor/appliance base

u

in water

or other fluids.

• Switch the appliance off at the On/Off switch

o

.

• Soiling or overflowing fruit juices should be cleared

away immediately, as fruit stains are difficult to
remove later.

• For cleaning the appliance housing and the power

cable, use a cloth that is only lightly moistened.

• Clean the stodger

q

, the juice container

t

, the

separate juice catchment container

h

, the hou-

sing cover

e

and the container for pulp and po-

mace

s

in warm soapy water then rinse them

off carefully.

The stodger

q

, the juice container

t

, the housing

lid

e

, the separate juice collector

h

and the con-

tainer for fruit pulp and vegetable mash

s

are sui-

table for cleaning in a dishwasher and can be cle-
aned there. To clean the filter

d

, use the supplied

nylon brush

g

:

• Turn the lid of the stodger

q

until the arrow

points to the opened lock

on the stodger

shaft. You can now remove it. The nylon brush

g

is inside the stodger

q

. To re-close the lid, place

it on the stodger so that the arrow points to the
opened lock

.

Then turn it until the arrow points at the closed
lock . The lid now sits firmly.

• Hold the filter

d

(with the underside upwards)

under running water and clean it with the nylon

brush

g

.

Colouring:

• Some fruits or vegetables could permanently dis-

colour parts of the juice extractor. This is not da-
maging and does not impair the appliance in its
functions.

Advertising