Silvercrest SEMR 850 A1 - Manual (Page 8)

8
GB
GB
Place a container with a capacity of at least half a litre under the coffee spout and cappuccino
maker (Fig. 5). Put the coffee brewing switch (O) on the coffee position ( ). Wait that water
comes out from the coupling seat of the filter holder. Open the steam dispensing knob (K) and
make water come out of the cappuccino maker.
Stop dispensing by putting the coffee brewing switch (O) in the high position. Close the steam
knob. Wait for the boiler temperature indicator lamp (L) to turn on. At this point the coffee
maker is ready to brew coffee.
HOW TO MAKE COFFEE
Put the perforated silicone disc (C) and the filter for ground coffee (D) into the filter holder (A)
in the order indicated (Fig. 6). Measure out the coffee in the filter and lightly press with the
specially provided presser: completely fill two measures for two cups of coffee, and fill only
one for one cup. Insert the filter holder into its seat.
Tighten well by turning it from left to right while making sure you have hooked it
properly onto the flange (Fig. 7).
Warning!
If too much ground coffee is put inside the filter, turning the filter holder may
prove difficult and/or you may get leaks from the filter holder when the cof-
fee is being dispensed.
The filter ring should be preheated for a few minutes to ensure a nice, hot cup of coffee. This
will not be necessary for the cups of coffee that follow.
Wait for the boiler temperature indicator lamp (L) to turn on. Position the coffee brewing switch
(O) to coffee brewing ( ): the coffee will start coming out of the spouts of the filter holder. To
stop the flow move the coffee brewing switch (O) to the high position. The minimum serving of
coffee is 50 ml.
Warning!
Like professional coffee makers, do not remove the filter ring when the coffee
brewing switch is turned on (in coffee brewing position ).
Warning!
Wait about ten seconds after the coffee has been dispensed before removing
the filter holder. To remove it, turn it slowly from right to left so as to prevent
splashes or spurts of water or coffee.
When warming up, your appliance may release small puffs of steam from the filter
holder; this is perfectly normal.
The boiler temperature indicator lamp (L) will go on and off at regular intervals indicating that
the boiler’s thermostat is keeping the water at the right temperature. When using the coffee
maker for the first time and thereafter, it is best to begin brewing coffee only when the boiler
temperature indicator lamp (L) is on.
Auto-off function
If the machine is turned on but not in use, the auto-off function operates after 30 minutes. This
function puts the machine in standby. The ON indicator light (P) is off. To restart the machine
press again the on/off switch (J).