Silvercrest SSM 180 A1 - Manual (Page 38)

35 SSM 180 A1
GB
MT
ATTENTION! PROPERTY DAMAGE!
►
Never fi ll the appliance with hard ingredients such as nuts, stalks, large
grains or seeds!
►
Never fi ll the appliance with hot ingredients!
►
Never use the appliance to crush ice cubes unless there is liquid in the
blender jug!
Before fi rst use
1) Remove all of the parts from the box and
remove the packaging material and any
protective fi lm.
2) Clean all components as described in Chapter
"Cleaning and care". Ensure that all parts are
completely dry.
Preparing ingredients
■ Remove all peel, such as orange peel or kiwi
skin, from the fruit.
■ Remove large pips and stones, such as found in
peaches, from the fruits.
■ Cut the fruit into small pieces (approx. 1 - 2 cm).
■ Chop herbs or salads into small pieces.
NOTE
► You can also crush ice cubes with this appli-
ance (max 50 g/approx. 2–4 ice cubes).
However, only add the whole ice cubes to
the blender jug 1 if other liquids are also
to be processed in it. Press the start button
6 in a pulsating manner when you process
whole ice cubes. Generally, however, we
recommend that you use already crushed ice
in this device.
Operating the appliance
1) Place the base 5 on a clean and level surface.
2) Fill the prepared ingredients in the blender jug 1.
Always add liquid ingredients fi rst and then the
more solid ingredients such as the fruit and/or
crushed ice.
ATTENTION! DAMAGE TO PROPERTY!
► Never fi ll the blender jug 1 with ingredients
up to more than the MAX marking! The
appliance will not be able to process the
ingredients!
3) Place the blade holder 4 on the blender
jug 1 so that the blade 3 extends into the
blender jug 1, and screw the blade holder 4
fi rmly in place.
4) Now place the blade holder 4 along with the
attached blender jug 1 onto the base 5 such
that the arrow on the base 5 is pointing to
the
symbol on the blade holder 4.
ATTENTION! DAMAGE TO PROPERTY!
► To turn the blade holder 4, only hold the
blade holder 4 and never try to turn the
blender jug 1! Otherwise the blender jug 1
will detach and the ingredients will spill out!
5) Turn the blade holder 4 so that the arrow on
the base 5 points to the symbol on the
blade holder 4. The blade holder 4 must
audibly click into place so that it sits fi rmly on
the base 5.
6) Insert the plug into a mains power socket.
7) Press and hold the start button 6 until the
smoothie has reached the desired consistency !