Silvercrest SHBS 3.7 A1 - Manual (Page 86)

84 GB
Shaving attachment3
WARNING!
Do not detach the shaving foil from the shaving foil frame, and
do not clean it using the cleaning brush16.
NOTE: from time to time, oil the cutting blade with a few
drops of acid-free oil (e.g. sewing machine oil). Attach the
shaving attachment to the hair and beard trimmer5 and let it
run for a few seconds without using it. Using a soft cloth, wipe
off the surplus oil, if necessary.
1. Remove the shaving attachment3.
2. Press the button on the side of the shaving attachment and
remove the shaving foil frame. While removing the shav-
ing foil frame, only hold it at the side and do not press
against the shaving foil.
3. Clean the cutting blade using the included cleaning
brush16.
4. Clean the shaving foil in the shaving foil frame under run-
ning water and allow it to dry completely before putting it
back on the shaving attachment3.
5. Put the shaving foil frame back onto the shaving attach-
ment3. While attaching the frame, make sure that the fas-
tening tabs on the shaving foil frame fit into the appropriate
recesses on the shaving attachment, and press the shaving
foil frame gently downwards until it audibly locks into place.
BB.5$ B%ERRN6HLWH0LWWZRFK'H]HPEHU