Silvercrest SHBS 3.7 A1 - Manual (Page 12)

10 GB
5. Charging
NOTES:
• Before first use (without cable), and for every charging
procedure afterwards, charge the hair and beard trim-
mer5 for approx. 90 minutes.
• When the batteries are nearly empty, the charging indica-
tor8 flashes red during operation. The device can then
only be used for a short time without being connected to
the electricity supply.
1. Place the battery charger10 on a level surface.
2. Connect the power unit9 to the battery charger10.
3. Switch off the device with the on/off switch7 if necessary.
4. Insert the power unit9 into a readily accessible wall sock-
et whose voltage matches the voltage stated on the rating
plate.
5. Put the hair and beard trimmer5 into the battery charg-
er10.
6. The charging indicator8 is lit red and the battery is
charged. When the battery is fully charged, the charging
indicator is lit green. When the battery is fully charged,
the device can be used for approximately 60 minutes with-
out being connected to the power supply.
6. Operation
Regardless of the charging state of the battery, the 5in1 hair and
beard trimmer can always be mains-operated.
1. For mains operation, ensure that the hair and beard trim-
mer5 is switched off.
2. Connect the power unit9 to the connector of the hair and
beard trimmer5.
3. Insert the power unit9 into a readily accessible wall sock-
et whose voltage matches the voltage stated on the rating
plate.
4. Switch on the device with the on/off switch7.
BB.5$ B%ERRN6HLWH'LHQVWDJ 'H]HPEHU