Silvercrest STW 32 - 60 A1 - Manual (Page 32)

GB
30 STW 32 - 60" A1
Assembly steps
Step 1: Attaching the mounting rails
♦ Check whether the supplied screws ( A , B or C ) fi t in the prepared holes
on the back of your TV set. If this is not the case, please use other suitable
screws and washers.
♦ Attach the mounting rail so that the screw heads for adjusting the tilt angle
face outwards and the hooks are facing downward. Screw the mounting rail
tight using the suitable screws (
A , B or C ) and washers E so that they
run parallel and are aligned at the same height.
♦ For TV sets with a fl at back, no spacers
D
are usually required. Fasten the
mounting rails with the appropriate screws and washers directly onto the
rear panel of the device.
♦ For TV sets with a curved rear panel, it may be necessary to use the supplied
spacers
D
between the TV set and the mounting rail.
Step 2: Attaching the wall bracket to the wall
♦ Start by selecting a suitable mounting height. The ideal height for a TV set is
parallel to the eye-level of a seated person.
♦ Hold the wall bracket up to the to the desired position on the wall to use
as a template and align it with the aid of a spirit level. Mark the 4 holes
with a pencil.
A B C
A B C
E
D
E
IB_106956_STW32-60A1_LB2.indb 30 04.12.14 09:52