Introduction / safety / setting up, Safety, Safety advice – Silvercrest Electrical Sockets User Manual
Page 7: Setting up, Preparing the remote control (fig. a)
7
GB
Introduction / Safety / Setting up
needles or other sharp objects into
them and thus get an electric shock.
Nevertheless, please keep the device
out of the reach of children at all times.
Safety
Safety advice
Read these operating instructions and
safety advice carefully. Look at the dia-
gram page and familiarise yourself with
all functions of the device before start-
ing it up for the first time.
Avoid danger to life from elec-
tric shock!
Only connect the radio-controlled
sockets to earthed 230 V~ domestic
sockets.
At all costs, avoid exposure to
damp and extreme temperatures.
Only use the radio-controlled sockets
in enclosed spaces. They are not
suitable for outdoor use.
Despite the child protection socket
8
, please keep the device out of
the reach of children at all times.
Avoid overloading the device.
Overloading can cause a fire hazard
or damage to the device. The maxi-
mum capacity is approx. 3.600 W
per radio-controlled socket.
Please contact the service department
immediately operational faults arise.
Do not open the device on any ac-
count. All necessary repairs should
only be carried out by the service
department or a specialist electrical
workshop.
Before cleaning always disconnect
the device from the mains supply. In
this case always remove the radio-
controlled electrical outlet socket
from the mains wall socket and
remove all plugs from the device.
Do not have one radio-controlled
electrical outlet socket inserted
behind the other.
Do not use any additional child
protection devices for the radio-
controlled sockets. The connection
between the plug and the radio-
controlled socket could be impaired
and risk from overheating then arises.
The radio-controlled sockets already
have a child protection device which
prevents children from putting any
objects into the socket.
Make sure that the connected
radio-controlled electrical outlet
sockets are freely accessible and not
covered by other objects.
If the device malfunctions, switch it
off immediately.
These instructions are a component
of the device. If you pass the device
on to a third party, these instructions
must also be handed on.
Setting up
Preparing the remote
control (fig. A)
1. Open the battery compartment on
the back of the remote control by
91210_silv_Funksteckdosen-Set_Content_DK.indd 7
18.07.13 10:13