Silvercrest SSM 141 C3 - Manual (Page 33)

33 GB/MT
Bringing into service / operation / Troubleshooting / Cleaning and Care
Bringing into service /
operation
Do not open the zip fastener on the
shiatsu massage cushion. It is pro-
vided for reasons connected with
the manufacturing process only.
note: The shiatsu massage cushion may give
off an odour of plastic on first use. This odour
will cease to develop after a short while.
note: Use the shiatsu massage device for a
maximum of 15 minutes. Longer use may lead
to over-stimulation and hence tension in the
muscles.
Insert the connector plug into the socket in the
massage device. Position the lead to avoid
creating a trip hazard.
If necessary pull the cover 5 over the shiatsu
massage cushion.
note: The shiatsu massage device can be
used with or without a cover
5 .
Position the shiatsu massage cushion on the
place you would like to have massaged e.g.:
• upper back (see fig. C)
• lower back (see fig. D)
• legs (see fig. E).
Switch on the shiatsu massage cushion with the
On/Off switch 1 .
Move the On / Off switch 1 up or down to
set the massage direction of the Shiatsu-heads:
Up for anti-clockwise rotation and down for
clockwise rotation.
You can switch the light and heat function on
or off with the light and heat switch 3 .
The light and heat switch 3 can be activated
during the massage operation as well as when
the cushion is switched off. However, the illumi-
nation and heating function is only available
during the massage operation.
note: Two of the massage heads 4 are
heated and illuminated during use.
Press the body part carefully against the
shiatsu massage cushion and gradually shift
you weight towards the device.
note: Do not lie, sit and stand with your full
weight on the moving parts of the shiatsu mas-
sage cushion and do not place any objects on
the cushion.
note: Ensure that you are experiencing the
massage as pleasant and relaxing. If necessary,
vary the pressure and / or your position. Stop
the massage at once if it is painful or unpleas-
ant.
Switch on the shiatsu massage cushion with the
On/Off switch
1 .
troubleshooting
Problem
Cause
Rectification
Massage heads rotate slower and slower
Too much pressure on massage heads
Reduce pressure on massage heads
Massage heads do not move
Device is not connected to the mains supply
Insert the plug-in mains adapter and switch on
the device.
note: Contact your specialist dealer or the service
address if your shiatsu massage cushion is still not
functioning properly.
Cleaning and Care
DAnGEr to
LIFE BY ELECtrIC SHoCK! Al-
ways pull the plug-in mains adapter
from the mains socket before cleaning the
shiatsu massage cushion. Otherwise there is a
risk of electric shock.
DAnGEr oF ELECtrIC
SHoCK! Ensure that the shiatsu
massage cushion is completely dry
before you connect the plug-in mains adapter
to the cushion. Otherwise there is a risk of
electric shock.
CAUtIon! DAnGEr oF MAtE-
rIAL DAMAGE! Do not use chem-
ical cleaners or scouring agents for
cleaning the shiatsu massage cushion. It may
otherwise be damaged.
93137_silv_Shiatsu_Massagegeraet_Content_LB5.indd 33 11.07.13 10:30