Setting the patriotact component properties – Sybase Version 2.2 User Manual
Page 24
Upgrading EAServer components
18
PATRIOTcompliance Starter Kit
select_scoreMatchStopWords = select word from
PatStopWords where priority = 1 and is_active = 1
QuickWordsThreshhold=30
Setting the PATRIOTAct component properties
Follow the instructions in this section to set the PATRIOTAct component
properties.
❖
Setting Controller component properties
1
Expand Servers | Jaguar | Installed Packages | PatriotAct.
2
Right-click Controller, choose Component Properties.
3
When the Controller properties sheet appears, click the Transactions tab,
choose Not Supported.
4
Click the Run As Identity tab, do this:
•
Set the Run As Identity property to system.
•
Set the Mapped to Jaguar Identity property to system.
5
Click the Resource Refs tab, do this:
•
In the Resource factories referenced in code group, set the Sharing
Scope of the jms/JMSQCFactory to shareable, then choose
javax.jms.QueueConnectionFactory as the Resource Link.
•
In the Resource factories referenced in code group, set the Sharing
Scope of the jdbc/DBConnection to shareable, then choose
PATRIOTdbConnection as the Resource Link.
6
Click the Resource Env Refs tab, do this:
•
In the Resource environmental references group, click
jms/ErrorQueue, then set the Link Value to error.
•
In the Resource environmental references group, click
jms/ResultQueue then set the Link Value to from_filters.
7
Click the MDB Type tab, set the Name property to to_filters.
8
Click OK to return to Jaguar Manager.
❖
Setting the FTPLoad component properties
1
Right-click FTPLoad, choose Component Properties.