Silvercrest SDM 1500 A1 - Manual (Page 61)

it GB
59 GB
trouBlesHooting
Warning!
Immediately switch off the appliance in case of operational faults and
electrical failures. Unplug it from the socket-outlet. Wait for the appli-
ance to cool down.
PROBLEMS CAUSES SOLUTIONS
On light off Not plugged in Check that the appliance is properly
plugged in. Check that there is current
on the power supply line. Try to plug the
appliance into another socket-outlet. If the
problem continues, contact an Authorised
Service Centre.
No steam comes
out of the nozzle
Steam dispensing button
not pressed
Press the steam dispensing button all the
way down
The appliance is not
ready for use
Press the steam dispensing button for thirty
(30) seconds or until you hear the noise of
the pump. Wait for the steam to come out.
Water shortage in tank. Fill the tank with fresh water by positioning
it directly under the tap up to the lower rim
of threading.
Incorrect insertion of the
tank in its seat.
Remove the tank and put it back in, making
sure it is in the right position.
The steam exit holes may
be blocked by limescale.
Contact an Authorised Service Centre.
Unexpected incre-
ase of the noise
level of the pump
Water shortage in tank. Turn off the appliance and fill the water
tank.
Incorrect insertion of the
tank in its seat.
Remove the tank and put it back in, making
sure it is in the right position.
Water leakage
from the nozzle
Possible condensation
residue in the steam duct
Press the steam dispensing button until you
see steam coming out. Position a soft cloth
so as to not dampen the floor. If water con-
tinues to come out, turn off the appliance.
Wait at least 5 minutes so that the steam
head and cloth cool down. Try again.