Silvercrest SDW 1200 B2 - Manual (Page 8)

- 5 -
• When removing the waffles ensure that you do
not damage the coating of the baking surfaces.
If you do, it will be harder to separate the waffles
from the surfaces.
Note:
The baking surfaces do not need to be greased
before each fresh waffle.
• After baking the last waffle, remove the power
plug from the wall socket and allow the appliance
to cool with the lid up.
8. Cleaning and care
Risk of electric shock!
Never open the casing of the appliance. There are
no user-serviceable elements inside. When the ca-
sing is open, there is the risk of receiving a fatal
electrical shock. Before cleaning the appliance,
remove the power plug from the wall socket and
allow the device to cool down completely.
Attention!
Under no circumstances may the components of the
appliance be submerged in water or other liquids!
There would be the risk of a fatal electric shock
upon the next use of the appliance should moisture
be present in the voltage conducting elements.
• First of all, clean the baking surfaces with a dry
paper towel to soak up the grease residue.
• Then clean all surfaces and the power cable with
a lightly moistened dish cloth. Always dry the
appliance well before using it again.
Attention!
• Do not use chemical or aggressive cleaning
agents or solvents. These could not only cause
damage to the appliance, they can also leave
traces that could be baked into the next waffles.
• Under no circumstances should you use hard
objects for cleaning. These could damage the
coatings of the baking surfaces.
For greasy soiling:
Apply some mild detergent onto a damp cloth. Use
it to rub the greasy soiling away. If this still does not
dissolve it, use a soft washing-up brush.
Remove the detergent residues thoroughly with a
wash cloth moistened with clean water. Completely
remove the detergent residues from the cloth with
clean water and then repeat the cleaning process
until all detergent residues are removed from the
waffel surfaces.
If you do not, there may be residues in the next waffles!
In the case of stubborn residues:
Place a piece of damp cloth on the stubborn
residues, so as to soften them. After that, you can
then remove the softened residues with a wet cloth.
IB_100073_SDW1200B2_LB4 28.05.2014 15:50 Uhr Seite 5