Silvercrest SKD 2300 A1 - Manual (Page 9)

SKD 2300 A1 7
• Do not short circuit the batteries.
• Remove the batteries if the device is not
used for a long time. Leaking batteries
could damage the device.
4.9 Material damage
Caution! To avoid material damage,
please observe the following conditions.
• Remove the batteries from the remote
control if you are not using it for a
prolonged period of time. Leaking
batteries could damage the remote
control.
• Ensure that the feet are fitted correctly
(see “5.1 Mounting the appliance” on
page 7), otherwise the floor might be
scratched or scorched.
5. Unpacking, setting up and inserting the batteries
5.1 Mounting the appliance
Before the appliance can be used, the feet 7
must be screwed on as follows:
1. Unpack the appliance from the
packaging.
2. Remove the transport packaging.
3. Check that the appliance shows no signs
of damage.
4. Slide the feet 7 from the outside into the
corresponding supports on the
underside of the convector.
5. Secure the feet 7 firmly using the screws
supplied.
5.2 Setting up the appliance
Note: As the appliance and heating
elements are supplied with a thin film of
grease, there might be a small amount of
smoke and odour the first time the appliance
is used. This is not harmful and will stop after
a short while. Please ensure meanwhile that
there is sufficient ventilation.
Warning! Ensure that there is
sufficient distance from the wall,
fixtures and other appliances. The
distance must be at least 1 m to
exclude the risk of fire.
1. Select a location in compliance with the
safety information (see “4. Safety
information” on page 4).
2. Plug the mains plug into a wall socket
that complies with the technical data.
Note:If you have plugged other power
consumers into the same circuit, check
that the maximum load for the installed
fuse is not exceeded, as otherwise the
fuse will trip.
5.3 Inserting the batteries
If the appliance is new or the batteries in the
remote control are flat, new type AAA/
LR03 batteries must be inserted.
1. Push off the battery compartment cover
on the underside of the remote control.
2. Remove the old batteries if present.
Note: Please observe the instructions
for disposal (see “9.2 Disposable/
rechargeable batteries” on page 10).
3. Insert new batteries.
Note: Ensure the correct polarity (+/
–). The correct polarity is shown on the
bottom of the battery compartment.
4. Close the battery compartment again.
RP100058 Konvektor LB4 Seite 7 Mittwoch, 30. April 2014 4:12 16