EAW JFX88 - Manual (Page 2)

SPECIFICATIONS JFX88
DIMENSIONAL DRAWING
INPUT PANEL
A & E SPECIFICATIONS
One Main Street, Whitinsville, MA 01588 508 234 6158 Toll Free 800 992 5013 FAX 508 234 8251 [email protected] www.eaw.com
EAW products are continually improved. All specifications are therefore subject to change without notice. JFX88/0004637/2 pp September 2002 Printed in USA
The 2-way full-range loudspeaker shall incorporate an 8-in LF
cone and a 1.4-in voice coil HF compression driver. The LF
cone shall be mounted in a vented enclosure tuned for opti-
mum low frequency response. The HF driver shall be loaded on
an axis-symmetrical, 1-in exit Wave Guide Plate™ with a nom-
inal conical beamwidth of 100 degrees. An internal passive
filter network shall provide all acoustical crossover and sys-
tem equalization requirements.
System frequency response shall vary no more than +3 dB
from 115 Hz to 20 kHz measured on axis. The loudspeaker
shall produce a sound pressure level of 94 dB SPL on axis at
1 meter with a power input of 1 watt, and shall be capable of
producing a peak output of 125 dB SPL on axis at 1 meter. It
shall handle 300 watts of amplifier power and shall have a
nominal impedance of 8 ohms.
The loudspeaker enclosure shall be irregularly trapezoidal in
shape. It shall be constructed of exterior grade Baltic birch
plywood and shall employ extensive internal bracing. It shall
be finished in wear-resistant textured black paint. Input con-
nectors shall be 2x Neutrik NL4 Speakon wired in parallel. It
shall include a pole mount cup for portable applications. One
3/8"-16 threaded mounting/suspension point shall be provid-
ed on the top and bottom of the enclosure. Four 5/16"-18
threaded mounting points for use with an Omnimount® Series
100 (or similar) shall be provided on the rear of the enclo-
sure. The front of the loudspeaker shall be covered with a
foam backed, powder coated perforated steel grille.
The 2-way full-range loudspeaker shall be the EAW model
JFX88.
Manufacturing tolerances are +/- 0.13 and +/- 1°
3.61
INPUT
.63
2.32
0002891 (A) 8/12/02
.91
BACK
45°
TOP
L
9.79
C
L C
FRONT
5.00
5.62
9.20
3.00
3.95
TOP HAT
22.5°
2X 2.75
4.00
2.41
4.42
BOTTOM
4.00
LEFT SIDE
17.46
2.87
2X 5.00
8.00
NOTES:
1. SYMBOL INDICATES MOUNTING POINT, 3/8-16 THREADED HOLE (T-NUT)
2. SYMBOL INDICATES MOUNTING POINT, 5/16-18 T-NUT FOR OMNI MOUNT
SERIES 100.
3. SYMBOL INDICATES CENTER OF BALANCE
4. WEIGHT APPROX. 27 LBS.
5. SHIPPING WEIGHT APPROX. 31 LBS.
6.15
GRILLE PARTIALLY SHOWN
RIGHT
SIDE
WHITINSVILLE, MA USA
JFX88
PIN 1--...--
PIN 1+...+
PIN 2--...NC
PIN 2+...NC
S/N