Powerfix Z31331 - Manual (Page 9)

9 GB/MT
Bike Hoist
§
Intended use
This product is intended for hanging standard
bicycles on a ceiling and for indoor use. It is
not intended to use in humid environments
and for commercial use.
§ Technical data
Max. loading: 20 kg (10 kg per hook)
Max. 4 m high ceiling
Safety instructions
Do not load more than 20 kg with the
product, otherwise there is a risk of injury
and / or damage to the product.
Check regularly that the product was
installed securely and retighten the
screws
1 , 8 if necessary.
Use the securing hook 7 at all times for
securing the bicycle. The bicycle may crash
down, otherwise.
Only use the product to hang bicycles on.
Replace a cord immediately if it is
damaged.
Ensure that the cord does not slide too
fast between your hands when lowering
the bicycle! It could lead to burns and
abrasions!
Ensure that the holding hooks 5 cannot
slip from the saddle and handlebar when
raising or lowering the bicycle.
Before drilling, please make sure the
mounting holes are far away from the
interior lines of the wall, such as electric
wirings, gas or water pipes.
The product cannot be used to lift any
kind of tricycles or bicycles with assistant
wheels.
No operation or maintenance is permitted,
if the bicycle is suspended on the bracket.
# WARNING! DO NOT STAND BELOW THE
SUSPENDED LOAD!
# SCREW 8 CANNOT BE REPLACED.
# SCREW 8 CANNOT BE SCREWED OUT
FROM THE FRAME.
# SCREW 8 SHOULD BE LOOSEN
DURING ASSEMBLY AND THEN BE
TIGHTEN BEFORE USE.
§ Assembly
Note: Use the four screws 1 and dowels 2
supplied. They are suitable for mounting on
concrete ceilings only.
1. Please refer to fig. A to D.
2. Screw
1 must be fastened tightly.
§ Operation
Operate the hanging system as shown in
Fig. D:
1. Attach the holding hooks
5 to the saddle
and handlebar of the bicycle.
2. Pull the cord downwards to raise the bicycle
to the appropriate height.
3. Slightly pull the cord outwards to activate
the locking mechanism and make sure the
locking gear is locked in stable condition,
then attach the securing hook
7 to bicycle
rack as shown in fig. D and then bind the
rest cord on bicycle.
4. For lowering the bicycle, put the rope to
unlock position, slightly pull down the cord
to release the lock, and then slowly lower
the bicycle (see fig. D).
§ Cleaning
Clean the product only with a slightly damp
cloth.
§ Disposal
The packaging is made entirely of
recyclable materials, which you may
dispose at local recycling facilities.
Contact your local refuse disposal authority for
more details of how to dispose of your worn-
out product.
79096_13_Powerfix_ES_IT_PT_02.indb 9 11/15/12 10:10 AM