Start-up, Setting the sensitivity of the sensor (ill. d) – Powerfix Z31712A/Z31712B Z31712C/Z31712D User Manual
Page 45
45
GB/MT
Remove the screws
2
from the front of the motion detector (see Ill. B).
Insert the cable through the cable opening of the base plate
4
.
Screw the base plate
4
to the desired position.
Connect the cable to the screw terminal
3
of the motion detector as
depicted in Ill. C.
Attach the cover of the connection area back to the base plate
4
by
screwing the screws
2
.
Start-up
Turn the electricity back on. The device is now ready for use.
Setting the sensitivity of the sensor (Ill. D)
Only models Z31712C/D
Note: the sensor range is max. 12 m (depending on the surrounding
temperature).
Turn the control knob SENS
8
in the direction „-” in order to reduce
the sensor range
1
.
Turn the control knob SENS
8
in the direction „+” in order to
increase the sensor range
1
.