Safety 1st Alpha Omega Elite - Manual (Page 25)

46 47
5
4
Fit loops on harness ends
onto the splitter plate.
Pull harness through the
back. Make sure the
harness goes OVER the
metal bar, BETWEEN metal
bar and plastic handle of
the harness/headrest
adjuster.
WARNING !
Reinstall Base:
Remove bar from base.
Line up shell with base.
Begin with the rounded
end, push bar completely
through hole, starting on
the right side
(A) , until it
locks in place. Refer to
“Removal of Seat Base”.
6
A
From bottom of shell,
release the elastic straps at
the bottom of seat and the
large elastic straps on the
side of seat.
Adjust backrest to lowest
position. Remove both
lower harness guides
(A)
in bottom of seat under
recline stand.
Push harness guide lip
toward outside of shell
with one hand while
pulling harness guide from
the front with the other.
A
1
2
Remove Seat Pad for Cleaning
Remove base and harness as described in the
“Belt-Positioning Booster” section.
Upper Harness Guides
Lower Harness Guides
Failure to place harness over the metal bar,
between bar and plastic handle of the
harness/headrest adjuster in back, can
result in serious injury or death.
4358-3340D Elite_Lux 3/13/06 3:08 PM Page 49