Powerfix FURNITURE TRANSPORT SET - Manual (Page 6)

6 GB
Cleaning / Storage / Service / Disposal Safety notices / Operation / Cleaning
Only use the furniture transport kit on even
surfaces.
operation
Placing furniture on
the rolling bases
Verify there is adequate space to work safely.
Remove objects such as other pieces of furni-
ture from about 1.5 m around the rolling
bases
4 .
note: to prevent unbalanced lifting, always
place the lever arm
2 under the side to be
lifted, paying attention to the load centre.
Grab the lever arm 2 by the handle 3 . This
requires the least amount of force.
Slide the flexible head 1 of the lever arm 2
under the centre of the piece of furniture
(see Fig. A).
Slowly push down on the lever arm 2 to raise
the piece of furniture (see Fig. B).
Keep the lever arm 2 pushed down.
Slide a rolling base 4 under each of the two
raised corners of the piece of furniture
(see Fig. C).
To lower the piece of furniture onto the rolling
bases
4 , slowly raise the lever arm 2
(see Fig. D).
Remove the lever arm 2 .
Repeat these steps on the opposite side of the
furniture.
note: each rolling base
4 has a swivel base
5 . This allows you to align the rolling bases
4 under the piece of furniture.
Sliding furniture
Align the rolling bases 4 so the casters point
in the same direction.
Move the piece of furniture to the desired
location using the rolling bases
4 .
Removing the rolling bases
notice:
To prevent unbalanced lifting, always place the
lever arm
2 under the side to be lifted, paying
attention to the load centre.
Centre the swivel head 1 of the lifting arm 2
under the piece of furniture.
notice:
Grab the lever arm
2 by the handle 3 . This
requires the least amount of force.
Slowly push down on the lever arm 2 to raise
the piece of furniture.
Keep the lever arm 2 pushed down.
Remove the rolling bases 4 .
Slowly raise the lever arm 2 to lower the load
Remove the lever arm 2 .
Repeat these steps on the opposite side of the
furniture.
Troubleshooting
The furniture is very difficult to move.
Align the rolling bases 4 so the casters point
in the same direction.
The piece of furniture can easily tip.
Place the four rolling bases 4 under the out-
side corners of the piece of furniture. The piece
of furniture should be all the way on the four
roller bases
4 .
Cleaning
aTTenTIon!
The lever arm 2 and rolling base 4 may be
damaged.
Never clean the lever arm 2 and the four
rolling bases 4 with petrol, solvents cleaners
harmful to plastics.
104019_pow_Moebeltransporter_content_HU_SI_CZ_SK.indd 6 05.01.15 15:52